The west patio that cooks at five
Sightlines
Measure on the plan, draw the area that actually needs privacy, then move A, B and C along the sightline. Every candidate is sized against the same geometry, and the one you pick is something to test with a sheet before anything is built.
The line
Open sightlineFrom this seat: The dining table. The line is toward Neighbour's upstairs window, a window. The section is this one line, not a view of the whole garden. A linked photograph is a note on this line, not a calculated performance.
No photograph is linked to the selected protected spot or observer yet. The geometry can still be read, but a kept candidate will have no photo-evidence reference.
The line itself does not move with the season, but a deciduous canopy can stop blocking it and view openness can change.
- Ground distance
- 43 ft
- Direction
- S · 162°
- Vertical angle
- 14.6°
- Line still open
- 100%
Estimate: Worked out, but at least one input was assumed rather than measured. These figures are read off the plan, so they are as good as where the dining table and neighbour's upstairs window were put.
Measure on the plan
Tap empty plan space to place the active tool, drag R1/R2, Z1/Z2/ZD and A/B/C, or tab to any handle and use the arrow keys. The fields below each panel set the same points by number.
To scale · to the measurements given: Drawn to scale from the measurements given. Not a survey. It is not a survey.
Ruler: tap twice to place R1 and R2, then drag either handle. Measuring does not move or save property geometry.
Field ruler
A distance read off the plan, not a change to the Property Record.
- Plan distance
- 43 ft
- Bearing
- S · 162°
- R1
- at the dining table
- R2
- 43 ft S of the dining table
Estimate: Worked out, but at least one input was assumed rather than measured. At least one end was placed by eye or by the model, so treat this as an estimate, not a tape.
Actual area to screen
The window, seating area, patio edge or other real zone the screen has to cover—not an assumed person-sized box.
How far the area reaches back from the edge, square to it. Set both ends first.
Candidate screens
Move A, B and C along the sightline on the plan or with the sliders. Height and width recalculate from the same geometry, and the marked view is read before and after each one.
- 7 ft high
- Height
- 7 ft
- Width
- Set the target zone
- From the spot
- 10 ft 8 in
- From the observer
- 32 ft
- Boundary
- Inside recorded boundary
- Marked view
- Unanswered
- 9 ft 9 in high
- Height
- 9 ft 9 in
- Width
- Set the target zone
- From the spot
- 21 ft
- From the observer
- 21 ft
- Boundary
- Inside recorded boundary
- Marked view
- Unanswered
- 12 ft 7 in high
- Height
- 12 ft 7 in
- Width
- Set the target zone
- From the spot
- 32 ft
- From the observer
- 10 ft 8 in
- Boundary
- Inside recorded boundary
- Marked view
- Unanswered
Estimate: Worked out, but at least one input was assumed rather than measured. Sizes are worked out on the plan, from a zone drawn by hand. “Marked view” only measures view corridors you actually marked. Boundary status does not establish ownership, setbacks, easements, structural adequacy or permission to build.
The line, from the side
Eye to eye, at true scale. A screen near the seat can be short because the line is still low there; near the window it has to be tall.
The section, in a table
From the dining table, nothing on the plan cuts the line to neighbour's upstairs window: it rises from 3 ft 11 in to 15 ft 1 in over 43 ft.
| What | From the dining table | Height | The line |
|---|---|---|---|
| The dining table (eye) | 0 in | 3 ft 11 in | Starts here |
| Screen A | 10 ft 8 in | 7 ft | Just closes it |
| Screen B | 21 ft | 9 ft 9 in | Just closes it |
| Screen C | 32 ft | 12 ft 7 in | Just closes it |
| Neighbour's upstairs window (eye) | 43 ft | 15 ft 1 in | Ends here |
Test it before anybody builds it
Candidate B is a hypothesis about where the line runs. A sheet on a pole for two evenings finds out whether it is right, for the price of a sheet.
- The test
- Hang a sheet or hold up a board about 9 ft 9 in high at B, 21 ft from the dining table, for two evenings at the hour that bothers you.
- If it worked
- Sitting at the dining table, you cannot see neighbour's upstairs window over it or round its ends.
- If it didn’t
- If you can still see neighbour's upstairs window over the top, it sits higher than the plan says; if you see it round an end, the zone is wider than drawn. Either way, nothing should be built to these numbers yet.
- Next evidence
- Photograph the view from the dining table with the sheet up, from the same spot both evenings, and measure how high neighbour's upstairs window actually is.
Buy nothing yetHold a sheet where the plan puts the screen before ordering a single panel.
Keep this candidate to test
Keeps the selected candidate and its target zone with this place. Reassessing reruns the geometry later, instead of treating today’s dimensions as settled. Keeping it builds nothing.
Candidates kept
Kept on this device with the place. Loading restores the zone and candidate; reassessing uses the current plan and month.
No candidate has been kept for this place yet.
Reference positions
Fixed quarter, halfway and three-quarter answers, kept as a check on the movable candidates.
| Where | From the dining table | Height needed |
|---|---|---|
| Near the protected spot | 10 ft 8 in | 7 ft |
| Halfway | 21 ft | 9 ft 9 in |
| Near the observer | 32 ft | 12 ft 7 in |
What this answers—and what it does not
Height and width are geometric sightline dimensions for the target zone and observer on the plan. They are not structural design, a property-line survey or permission to build. Wind loading, footings, codes, easements and ownership remain separate questions.
Edit the planEvery observer from the dining table